Servicing & Warranty

  • Remove and treat filters with filter cleaner. Recommend new filters where necessary
  • Run chemical system flush (antibacterial and degreaser fluid used to clean internal pipework)
  • Remove tub sides (where accessible) and inspect pipework for leaks and obvious faults
  • Electrical check on control system
  • Clean and protect hot tub lid with vinyl protectant
  • Drain tub and clean tub shell with surface cleaner
  • Vacuum out residual water in the tub
  • Remove jets (where possible) clean and refit. Some jets may not be possible to remove without damaging them due to scale build-up or other chemical damage. The customer will be advised if this is the case.
  • Tighten all pump unions, inspect, and replace any small seals if required
  • Refill hot tub with fresh water, check the operation of pumps, blower, lights, and heater
  • Rinse and refit filters
  • The service typically takes 3 hours

N.B. For us to proceed with the service, the tub must be filled with water and switched on. Hot tub parts, plumbing fittings, seals etc are additional to the service cost. If the tub is surrounded by decking or other structures, gazebo, summer house etc, the tub owner is responsible for ensuring access is available to the internal control box and circulation pump at the very minimum.

Price includes VAT

  • Drain tub and clean tub shell with surface cleaner
  • Vacuum out residual water in the tub
  • Clean filters
  • Refill with fresh water
  • Reset chemicals ready for your new guests

Price includes VAT

  • 2 Years Hassle Free Tubbing!
  • Parts Included
  • Labour Included
  • 10% discount on all chemical and filter purchases